Protective film manufacturer, protective film film classification_screen protector

There are generally the following methods to remove the protective film of the LCD screen: 　　 1. Use the tip of your fingernail to remove it from the corner (removing from the sharp corner, the edge gap may be a bit difficult), and gently lift it without damaging the screen. Just a little bit, pull it down.　　2, the general protective film is more than one layer, use the non-used layer to pry a little bit from the corner and pull it off.　　3. Use strong adhesive to stick it on the surface of the protective film, and use the adhesive force to tear it off. Protective film film classification: PE protective film, PET protective film, OPP protective film, PVC protective film, CPP protective film, electrostatic film, release film, anti-static film, high temperature tape, stretch film, packaging film, PE/ PVC wire film, heat shrinkable film, sheet, Apple computer protective cover, pre-coated film and fresh-keeping film. PET protective film is currently the most common type of protective sticker on the market. In fact, the plastic Coke bottles we usually see are made of PET, also called PET bottles. The chemical name is polyester film. The characteristics of PET protective films are The texture is relatively hard and scratch-resistant. And after long-term use, it will not turn yellow and oil like PVC materials. But the general PET protective film is electrostatically adsorbed, which is easier to foam and fall off, but even if it falls off It can be reused after washing in clean water. The price of PET protective film is much more expensive than that of PVC.　　AR material screen protector. AR is a synthetic material, generally divided into three layers, silica gel is treated for glare absorption, and the frosted protective film is treated in this way. HC is hardness treatment, which is the treatment method used for high-transmittance protective films. This The characteristic of this screen protection film is that the screen is non-reflective and has a high light transmittance (above 95%), which will not affect the display effect of the screen. Moreover, the characteristics of this kind of screen protection film on the surface of the material is that the screen does not reflect light, and the light transmittance is high (above 95%), which will not affect the display effect of the screen. Moreover, the surface of the material is treated with a special process, and its texture is relatively soft, and it has strong anti-friction and anti-scratch ability. It will not be scratched after long-term use. The adhesive is made of chemical silica gel adsorbed on the mobile phone screen, so it will not The screen itself causes damage and will not leave a mark after being torn off. It can also be reused after cleaning. The attached layer is PET as the middle layer and the outer layer is a special treatment layer. The special treatment layer is generally divided into two types, AG treatment layer and HC For the treatment layer, AG is anti-glare treatment, and the frosted protective film uses this treatment method. HC is the hardness treatment, which is the treatment method used for high-transmittance protective films.