Mobile phone tempered film, explosion-proof tempered film, mobile phone protective film

Whenever a new machine is started, people will add a screen protective film to its screen, but they are not able to stick the film, and the screen protective film will generally be pasted by the seller of the film. However, if the screen protector is found to be crooked or worn out and needs to be replaced in the future, it is quite troublesome to go to the merchant to do it again. In fact, filming is not a 'difficult task'. As long as you choose high-quality screen protection film products and have a clear understanding of the filming process, it is really not difficult to do it yourself. The following will give you a detailed description of the entire process of screen protector filming. 1. Clean the screen Use a BG cloth (or soft fiber cloth or glasses cloth) to wipe the screen to thoroughly clean the phone screen. It is best to wipe the screen in a clean and tidy indoor environment to reduce the impact of dust on the film, because thorough cleaning before filming is necessary, as everyone knows, if you accidentally get dust on it, it will directly affect the results of the film. , It may cause bubbles after the film is applied, and may cause the film to fail. Many poor-quality screen protectors are because they cannot be cleaned up after dust enters during the filming process, which directly destroys the silicone layer of the screen protector, making the film scrapped and unusable. Use the BG dust remover to clean up stubborn dirt. After cleaning with a cloth, if there is still stubborn dirt on the screen, it is important not to use a damp cloth to clean it. Just stick the BG dust removal sticker on the dust, then lift it up, and use the stickiness of the dust removal sticker to clean up the dust. After using the BG dust removal sticker, put it back on the original backing paper, and it can be used repeatedly. 2. Get the initial impression of the film. Take the screen protection film out of the package, do not tear off the release film, put it directly on the phone screen to get the initial impression of the film, especially observe the adhesion of the edge of the film and the phone screen , Have a general understanding of the location of the film, which will help the subsequent filming procedure. 3. Tear off a part of the release film No. ① and observe the label on the screen protection film, tear off a part of the release film marked '①Each screen protection film product is divided into three layers, of which ① and ② are release films, which are used to protect the screen protection film in the middle. 4. Slowly paste the screen protector to the mobile phone screen. Align the adsorption layer of the screen protector with the corners of the screen. Make sure that the position is aligned, and then paste it carefully. While pasting, tear off the release film ①. If bubbles are generated during the pasting process, you can pull the film back and re-attach it. After confirming that the film position is completely correct, completely tear off the release film ①. After the entire screen protector is attached to the screen, if you find that there are still bubbles, you can use the BG scratch card to scratch the screen once to exhaust the air. Completely tear off the release film No. ② and completely tear off the release film No. ②, and wipe the screen with a cloth. The entire filming process is declared complete. 5. The screen must be thoroughly cleaned before filming, especially not leaving dust. After the No. 2 release film is torn, pay special attention to not touching the adsorption layer with your fingers, otherwise the filming effect will be affected. In the process of pasting, do not tear the release film at one time, you should tear it while sticking it. Make good use of scratch cards for defoaming.