Guangdong mobile phone protective film manufacturer, screen protective film manufacturer, PET screen protective film manufacturer
Guangdong mobile phone protective film manufacturer, screen protective film manufacturer, PET screen protective film manufacturer. How to apply computer screen protective film, which is somewhat similar to mobile phone screen protective film, you can see the following steps. 1. Align the screen protection film surface marked with ① on the screen, and pull the ① layer release film label outward, slowly tearing part of the layer, please be careful not to touch the adsorption layer (middle layer) of the protective film with your fingers 2. Align the adsorption layer to the corners of the screen, make sure the position is aligned, and carefully smooth it while tearing off the release film No. ① on the back layer, because the current screen protection film has an electrostatic automatic adsorption function, and generally does not require too much ironing When sticking the film, the action should be slow. It is recommended to stick it along the long side of the screen, from point to line, and from line to surface. 3. After affixed, start from the label of ② and tear off the release film of this layer (the layer facing you). Matters needing attention 1. Clean the screen thoroughly before sticking the film. 2. After the release film No. ① on the back layer is torn off, be careful not to touch the adsorption layer (middle layer) with your fingers, otherwise the effect of the film will be affected. 3. During the pasting process, do not tear the release film ① at one time. You should tear it while pasting it. When the bubbles are found to pull back a little, use a cloth to flatten it.